Crackle Frame Shadow Box

I thought I'd try something a bit different today - a shadow box. I bought a few of these frames a while back and have been waiting for an excuse to have a go at one! All stamps used in this project were from the Artistic Stamper, as were the watch parts.

The inside of the frame was painted with espresso paint dabber, and the front and outer edges with frayed burlap crackle paint. When the crackle paint had dried, I applied walnut stain distress ink to it to accentuate the cracks in it. The "Time is..." phrase was stamped with black Staz-on. The crackles don't show up that well in this photo, but they're there, believe me!

The background card inside the frame was tinted with walnut stain distress ink applied with Cut'n'Dry foam and then flicked with water to produce lighter spots on it. I then crumpled it up, flattened it slightly, then rubbed it lightly more walnut ink to highlight the crumple folds. I then turned it over, spritzed it with a little water and ironed it flat (yes, yes... I know.... enough already! Those of you that know me find it hard to imagine me with an iron in my hand, but you have to believe me, it's true! Would I lie to you, dear reader?) For some reason that I have not yet fathomed, this produced light blue/grey marks where the crumples had been. I'm not complaining, I think it looks great, I just wish I knew how it had happened!

The card was then stamped with a calligraphic mat and tape measure stamp in brushed corduroy distress ink, and glued into the frame.

The watches were created as follows (going from right to left):

• stamped in walnut stain distress ink
• stamped and embossed with gold embossing powder then tinted with walnut ink
• stamped with black Staz-on onto acetate, run through a Xyron sticker-maker to make the back sticky, then gold leaf was applied to the back. It was then scrubbed with a rough brush to distress it slightly.
  

The watches were layered with 3d foam pads.

The watch face and glass were layered in the lower left corner with a spiral paper clip, tinted with gold Krylon pen.

The key in the top right corner was a real one I had lying around the house, which was suspended from jute twine and held in place with 2 drawing pins coloured with a copper Krylon pen.

The chipboard key was from Maya Rd. It was coloured with gold Krylon, sanded to distress the edges and gently edged with walnut distress ink. It doesn't show up well in this photo, but the word ORIGINAL was then stamped onto the key using black Staz-on ink.

And that's about it! It took a fair while to make, but I'm really pleased with it. I hope you like it too! :o)